- 8 inputs AC/DC 12...230 V
- 8 relay contact outputs
- Rated contact voltage AC 230 V
- Rated contact operating current 16 A, p.f. = 1
- Electronics power supply via an integrated power supply unit for AC 230 V
- Device functional even without bus connection or if bus voltage absent or bus communication interrupted or not yet activated
- Push button to switch between bus and direct mode
- Push button for each output to switch the output in direct mode via a toggling function by a short actuation and for changing the output mode between remote control relay and time switch relay by holding down the push button for some seconds
- Device preset at the factory for direct switching of an output through a toggling function via the input of the same name
- Selectable function for each input when using the Engineering Tool Software (ETS):
- Switching status / binary value transmission
- Switching, short / long operation
- Single button dimming, single button sun protection control, 1-button group control (sequence control)
- 1-bit scene control
- 8-bit scene control, 8-bit value, edge-triggered, 8-bit value, short / long operation
- 16-bit floating point value, edge-triggered, 16-bit value, short / long operation, 16-bit value, edge-triggered, 16-bit floating point value, short / long operation
- Selectable function for each pair of inputs:
- 2-button dimming with stop telegram or with cyclical sending
- 2-pushbutton shutter/blind control
- Selectable blocking / releasing of each input via a corresponding blocking object
- Sending of the input objects after a change of status
- Selectable logic operation (AND/OR) for one input with a further communication object and with variable start value of the logic operation at bus voltage recovery
- Setting by means of the ETS, whether all outputs are to be configured identically or individually
- Selectable mode for each output (normal mode, time switch mode)
- Optional addition of a night mode object for each output for time-limited switching On of the output (and hence the illumination) at night
- Variable On and Off delay times for each output
- Variable On period in night mode or in time switch mode
- Selectable warning signal prior to imminent switching-off by means of three-times short off and on switching (flashing) in night mode or in time switch mode
- Optional status object per output for status reporting
- Sending of status objects on request and/or automatically after a change
- Integrated 8-bit scene control and linking of each output with up to 8 scenes
- Selectable switching state for each output at mains or bus power failure as well as after bus or mains voltage recovery
- Integrated bus coupling unit with only half a standard bus load
- Bus connection via bus terminal or contact system to data rail
- Modular installation devices for mounting on TH35 EN 60715 mounting rail
