DINUY RE KNT 110 Dimmer KNX 1/10V 3 channels (DIN rail)
€199,04 Excl. tax
€353,84 Excl. tax
€240,84 Incl. tax €428,15 Incl. tax. Out of stock, but available
€240,84 Incl. tax €428,15 Incl. tax. Out of stock, but available
1-10V Dimming Actuator for Drivers or Ballasts, with fluorescent tubes or LED lighting.
3 output channels, with a maximum of 3A per channel.
It has 2 control elements for switching/dimming the load Read more
Specifications
Brand:
Dinuy
Article number:
RE KNT 110
EAN:
8422447014693
Availability:
Out of stock, but available
Information
Description:
1-10V Dimming Actuator for Drivers or Ballasts, with fluorescent tubes or LED lighting. 3 output channels, with a maximum of 3A per channel. It has 2 control elements for switching/dimming the load: · K relay: 3 independent contacts that open or close the phase output to the drivers or ballasts. Therefore, with this relay, we will control the power supply of the luminaires. If a greater number of electronic ballasts or drivers with high inrush currents are to be connected, a separate load contactor is recommended. · 1-10V Analogue Output: dimming signal. The number of electronic ballasts or drivers that can be dimmed via the 1-10V output, depends on the ballast-specific 1/10V input current of the types used. Different functions and parameters can be enabled and parameterised by the ETS: staircase lighting timer with warning function, dimming speed, scene control (up to 5), sequential operation, soft turn on/off, etc. Outputs can be operated manually (even without bus connection). The device has integrated overload, short-circuit and over-heating protection. Modular installation device. DIN-rail mounting. 5-modules wide. Programming and commissioning by ETS4 or later versiom.
| Technical characteristics RE KNT 110 | |
| Product reference | RE KNT 110 |
| Power Supply (V) | 230VCA |
| Frequency (Hz) | 50 |
| Consumption | 13mA |
| Output channels | 3 |
| Switching capacity (A) | 3 |
| Type of load | 1-10V Driver |
| Halogen lamps with ferromagnetic trafo (W | 0 |
| Motores (VA) | 0 |
| Maximum current input 1/10VDC (mA) | 500 |
| Maximum current output 1/10VDC (mA) | 100 (por Canal) // 270 (en Total) |
| Maximum Number of Equipments | 150 |
| Binary/Analogic Inputs | 0 |
| Installation | DIN Rail |
| Module number | 5 |
| Control | KNX Bus |
| Programming by | ETS4 or higher |
| Compatible with | KNX |
| Connection terminals | Captive Screws |
| Cable section (mm2) | 6 |
| Minimum Storage Temperature (ºC) (min) | -30 |
| Maximum Storage Temperature (ºC) (max) | 70 |
| Minimum Working Temperature (ºC) (min) | -5 |
| Maximum Working Temperature (ºC) (max) | 45 |
| Protection Degree | IP20 , UNE 20324 |
