Collection

Touch control TC5 UP 205/22 black or white
Aluminium and glas housing
Capacitive touch colour display 5", 480 x 854 pixels
LED colour light strip as orientation light, respectively to signal alarms
Integrated room temperature sensor

QMX3.P37-1BSC
Room operator unit KNX with temperature sensor, segmented backlit display, configurable touchkeys, LED display, black

Two DALI outputs with DALI-2 certification acc. to IEC 62386-101 and 103, each for communication with up to 64 DALI ballasts

IP Router Secure N 146/03 5WG1146-1AB03

8 inputs AC/DC 12...230 V
8 relay contact outputs
Rated contact voltage AC 230 V

For connection of a modular bus device to the bus line
10-pole BTI socket (BTI - Bus Transceiver Interface) for plugging of bus terminal devices with BTI connector

For data exchange between two KNX bus lines with telegrams of up to 64 byte
For use as line coupler for connecting a line to the main line or as backbone coupler for connecting a main line to the backbone....

UP 220/21
Pushbutton interface 2 x potential-free contact, output for LED control
2 inputs / outputs

Compatible with USB 2.0 and USB 3.0
For isolated access to the bus line over the built-in USB socket (type B)
For connection of a PC for addressing,etc
Support of bus telegrams with up to 64 bytes length

KNX Power supply unit DC 29 V, 640 mA with additional unchoked output, N 125/22

For mounting in AP 118 automation module box or AP 641 room control box

One relay contact per output
Rated contact operating voltage: AC 230 V
Rated contact frequency: 50/60 Hz
Rated contact current: 16 A

Electromotive, proportional (constant) valve actuator with LED valve position indication and with integrated bus coupling unit for direct connection to KNX:
For latching to valve adapter

DIN rail mounted device for mounting on rail TH35 according to DIN EN 60715

Passive infrared detector for ceiling mounting indoors
Adjustable sensitivity of detection
Mixed light measurement

2 channels
Electrically interlocked relays to reverse the direction of rotation
Integrated electronics for detection of the actuation of an electromechanical limit switch and with auto-calibration of the travel time from one limit switch to the other

The service interface consists of:
OCI702 service interface
USB 2.0 cable (Type A / B)
KNX service cable for Synco™ controllers (RJ45 / RJ45)
KNX service cable for Desigo™ TRA (RJ45 / jack plug 2.5 mm)
KNX service cable (RJ45 / KNX bus terminal)

DIN rail mounted device for mounting on rail TH35 according to DIN EN 60715

DIN rail mounted device for mounting on rail TH35 according to DIN EN 60715

Ultrasound for reliable detection for ceiling installation indoors even behind objects
Additional detection options through PIR technology
Horizontal 360° motion detection area

Rated contact frequency: 50/60 Hz
2 floating relay contacts
Contact rated current according to DIN EN 60669-1: 10 A (resistive load)

KNX Power supply unit DC 29 V, 160 mA with additional unchoked output, N 125/02

BACnet Application Specific Controller (B-ASC) as Gateway between KNX TP and BACnet IP
Up to 250 BACnet objects
Up to 455 BACnet COV subscriptions

Two outputs for switching and dimming resistive, inductive or capacitive loads
Automatic adjustment to leading edge or trailing edge control, depending on the type of load
Rated operational voltage AC 230 V