MINIPAD KNX – 8 Kanäle mit intelligenter Virtual Holder Logic
€141,57 Incl. tax €226,27 Incl. tax. Out of stock, but available
Specifications
Information
Link zur Website von eelectron
MINIPAD KNX
8 channels with smart Virtual Holder Logic
Article number: MB80D01KNX
Available variants
- MB80D1KNX-WH – Bianco (white)
- MB80D01KNX-BL – Nero Matte (matte black)
- MB80D1KNX-SWH – Bianco Helvetia (Helvetia white)
Short explanation: Virtual Holder Logic
Virtual Holder Logic (VHL) is an intelligent virtual card- and keyholder logic that detects the presence of people in a room without a physical card reader. By combining data from door contacts, digital inputs, motion detectors and time-based logic, the system automatically recognises whether a room is occupied, vacant or entered unexpectedly. This enables efficient automation of HVAC, lighting and hotel room behaviour.
Product description
The MINIPAD KNX from the eelecta® series is an advanced KNX control panel with 8 fully configurable buttons for lighting control, dimming, blinds and shutter management, and other KNX command and control functions. The panel is equipped with 8 white LEDs and 1 RGB LED, all freely configurable via ETS. On the rear side, 3 inputs are available: two for potential-free contacts and one digital/analogue input for additional sensors or NTC measurements.
Applications
- Lighting control: switching and dimming
- Control of blinds, slats and shutters
- Scene and sequence control
- Climate control via integrated thermostat
- Hotel rooms (with smart Virtual Holder Logic)
- Smart building automation and comfort solutions
Main features
- 8 configurable buttons with LED status indication
- 8 white LEDs + 1 RGB LED fully ETS-configurable
- 3 rear inputs: 2× potential-free, 1× digital/analogue input
- Integrated temperature sensor and thermostat with 2 zones
- PI controllers for heating, cooling, valves and 2/4-pipe fan coils
- 16 logic blocks for advanced logic and calculation functions
- Algorithms for temperature, humidity and dew point calculation
- Virtual Holder Logic for accurate presence detection and hotel automation
- Support for KNX Data Secure
- Integrated KNX communication interface
Technical data
Power supply
- Via KNX/EIB bus: 21…30 V DC
- Maximum current consumption: 20 mA
Inputs / buttons
- 8 buttons
- 2 inputs for digital (potential-free) contacts
- 1 input configurable as digital or analogue (NTC)
- Maximum cable length: ≤ 10 m
- Scan voltage: 3.3 V DC
Outputs / LEDs
- 8 white LEDs
- 1 RGB LED (freely configurable)
Connections
- KNX bus via 2-pole terminal (0.8 mm Ø)
- Input connector suitable for 24 AWG wiring
Mechanical data
- Housing: polycarbonate and ABS
- Weight: approx. 130 g
- Protection class II (EN 61140)
Electrical safety
- Pollution degree: 2 (IEC 60664-1)
- Protection rating: IP20 (EN 60529)
- Protection class III (IEC 61140)
- Overvoltage category III (IEC 664-1)
- Bus voltage SELV DC 29 V
Important notes
- Configuration via ETS, including KNX Data Secure.
- Supports up to 300 group addresses and 350 associations.
- For indoor installation only.
- Part of the eelecta® series by Eelectron.
