Siemens

- 1 channel
- Modular installation device for mounting in AP 118 automation module box or AP 641 room control box

One relay contact per output
Rated contact operating voltage: AC 230 V
Rated contact frequency: 50/60 Hz
Rated contact current: 16 A

One relay contact as switching element
Bus-powered electronics
Integrated bus coupling unit, Bus connection via bus terminal block
Type of protection: IP 20
Rated contact voltage AC 230 V
Rated contact frequency: 50/60 Hz
Rated contact current 16 AX

Rated contact frequency: 50/60 Hz
2 floating relay contacts
Contact rated current according to DIN EN 60669-1: 10 A (resistive load)

UP 220/21
Pushbutton interface 2 x potential-free contact, output for LED control
2 inputs / outputs

2 channels
Electrically interlocked relays to reverse the direction of rotation
Integrated electronics for detection of the actuation of an electromechanical limit switch and with auto-calibration of the travel time from one limit switch to the other

3 floating relay contact
One relay contact per output as switching element
Contact rated current according to DIN EN 60669-1: 6 A (resistive load)

Rated contact current according to DIN EN 60669: 6 AX (70 µF fluorescent lamp load), 10 A (resistive load)

4 Inputs for AC/DC 12...230 V
Max. cable length, unshielded, twisted 100 m
Bus-powered electronics

With 4 inputs / outputs each configurable for potential-free contacts or for control of an LED (max 2 mA)
With integrated bus coupling unit, bus connection via bus terminal
8-wire plug-in cable set, 280 mm long, extendable to a max. of 10 m

8 inputs AC/DC 12...230 V
8 relay contact outputs
Rated contact voltage AC 230 V

Brightness measurement, temperature measurement, sun protection control, lighting control
For the detection and transmission of brightness and temperature

For fixing the presence detectors UP 258D12 and UP 258E22 and the brightness sensor UP 255D21 as a surface mounting device

Electromotive, proportional (constant) valve actuator with LED valve position indication and with integrated bus coupling unit for direct connection to KNX:
For latching to valve adapter

IP Router Secure N 146/03 5WG1146-1AB03

For operation with a KNX power supply without integrated choke or for connection to the unchoked output of the KNX N 125/x2 power supplies
Low-voltage terminal for unchoked voltage and bus
Modular installation devices for mounting on TH35 EN 60715 mount

Two DALI outputs with DALI-2 certification acc. to IEC 62386-101 and 103, each for communication with up to 64 DALI ballasts

BACnet Application Specific Controller (B-ASC) as Gateway between KNX TP and BACnet IP
Up to 250 BACnet objects
Up to 455 BACnet COV subscriptions

Per input one AC or DC contact in the range of 10...230 V
Per input direct operation function on the device for simulation of input status and indication oft the input status via LED

8 Inputs for AC/DC 12...230 V,
8 Inputs for floating contacts

• 2 DALI outputs with DALI-2 certification
• Control capacity for up to 20 DALI-ECGs per DALI output
• DALI output voltage of 19 V, short circuit resistant

Two outputs for switching and dimming resistive, inductive or capacitive loads
Automatic adjustment to leading edge or trailing edge control, depending on the type of load
Rated operational voltage AC 230 V

Rated contact current according to DIN EN 60669: 16 AX / 20 AX (200 µF fluorescent lamp load)

Rated contact current according to DIN EN 60669: 16 AX / 20 AX (200 μF fluorescent lamp load)